Removing The Drive Bay Assembly - Gateway ALR 8200R User Manual

52 Gateway ALR 8200R User's Guide

Removing the Drive Bay Assembly

Before you can install, remove, or replace a device in the drive bay
assembly, you must remove the entire assembly from the drawer. Drives that
are housed in the drive bay assembly include the 3.5-inch diskette drive, the
5.25-inch CD-ROM drive, and the 3.5-inch drives in the RAID Cage bay.
The instructions for removing these drives will refer to this section.

Removing the Drive Bay Assembly

Turn the system power off.
1.
2. Open the system by removing the top cover.
3. Unplug the data and power cables to all devices in the drive bay
assembly.
Remove the six screws that secure the drive bay assembly to the
4.
bottom of the drawer.
Figure 26: Removing the Drive Bay Assembly