Installing A 3.5-Inch Drive In A 5.25-Inch Drive Bay - Gateway 7400 System Manual

Installing a 3.5-inch drive in a 5.25-inch drive
bay
Additional 3.5-inch hard drives can also be installed in the server in the empty
5.25-inch drive bays. A 5.25-inch filler tray, three of which came installed in
your server, is required for this type if installation.
To install a 3.5-inch drive in a 5.25-inch drive bay:
1
Turn off the system and disconnect the power cord, modem cord (if
installed), and all external peripheral devices.
2
Observe all safety and static electricity precautions. (See "Preventing static
electricity discharge" on page 22.)
3
Remove the bezel. (See "Removing the bezel" on page 25.)
4
Remove the left side cover panel. (See "Removing the side cover panel"
on page 26.)
5
Locate an available 5.25-inch drive bay.
6
Grip the mounting rails firmly with thumb and index finger and pull
the filler tray carefully straight out of the drive bay.
7
Leave the mounting rails on the filler tray.
35
Drives