Removing A Diskette Drive From The Converted Hard Drive Bay - Gateway 9415 User Manual

15
Connect the other end of the data cable to the system board. See
page 6 for the location of the connectors on the system board.
16
Reinstall the bezel, if required, by snapping it into place on the front of the chassis.
17
Follow the instructions in
18
Reconnect all power cords and peripheral device cables, then turn on the server.
Removing a diskette drive from the converted hard
drive bay
To remove a diskette drive from the converted drive bay:
1
Follow the instructions in
sure that you turn off the server, then unplug the power cord(s) and all other cables
connected to the server.
Caution
2
Follow the instructions in
3
Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
4
Disconnect the data cable from the system board. See
the location of the connectors on the system board.
5
Disconnect the power cable from the back of the interposer board.
6
Push in on the blue lever at the back of the drive carrier to release the drive carrier
from the drive bay, then slide the diskette drive carrier and cables out through the
front of the server.
7
Remove the cables from the interposer board.
8
Remove the single screw securing the interposer board to the drive carrier, then remove
the interposer board.
9
Remove the four screws securing the rails to the carrier, then remove the rails. (See
the illustration on
10
Remove the two screws securing the diskette drive in the carrier, then slide the drive
out of the carrier.
"Closing the server case" on page
"Preventing static electricity discharge" on page
The diskette drive is not hot-swappable. Before installing or removing
the drive, make sure that power is turned off and the power cord is
unplugged.
"Opening the server case" on page
page 52.)
www.gateway.com
"System board" on
44.
42.
"System board" on page 6
41. Make
for
55