Removing And Installing A Diskette Drive - Gateway E-9525R User Manual

CHAPTER 4: Installing Components

Removing and installing a diskette drive

The diskette drive is not hot-swappable.
Before installing or removing the drive,
make sure that power is turned off and
the power cord is unplugged.
38
Make sure that the tray's release lever is open, then slide the new drive
6
fully into the empty hot-swap drive bay.
Push the lever back into place, then turn the lock clockwise to secure the
7
hard drive in the bay.
Reinstall the bezel, if required, by snapping it into place on the front of
8
the chassis.
To remove and install a diskette drive:
Caution
Follow the instructions in
1
page 30. Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
2
Follow the instructions in
3
Disconnect the USB cable from the diskette drive.
4
Lift the blue locking tab on the back of the diskette drive tray, then push
5
the drive tray out the front of the media cage.
"Preventing static electricity discharge" on
"Opening the server case" on page
Blue locking tab
www.gateway.com
31.