Programming Methods - Panasonic KX-TD500 User Manual

3.1 User Programming Instructions

Programming Methods

Advancing to the next stage
When "SYS-PGM NO? " is displayed, you can select one of the following:
• To go to program [000], press the NEXT button.
• To go to another program, enter the 3-digit program address.
Entering Characters
You can enter characters to store names for speed dial numbers, extension numbers, etc.,
by using the dialing key pad and buttons.
Each of the twelve dialing keys on the dialing key pad represents seven characters. Refer
to the "Station Speed Dialing Number / Name Assignment (KX-T7235, KX-T7436)" in
Section 2.2 Station Programming.
Storing your data
Press STORE to store your data.
• The STORE indicator lights red and a confirmation tone sounds.
* Confirmation tone (one beep)
After pressing STORE, you will hear a beep. This informs you that storage is completed.
*Alarm tone (three beeps)
If you hear this alarm, your entry is not valid.
Making another selection within the same program address
• To go to the next selection, press NEXT.
• To go to the previous selection, press PREV.
• To make a specific selection, press SELECT and then enter the number.
Accessing another program address
After pressing STORE, you can access another program by one of the following two methods:
(1) • To go to the next larger program address:
(2)
3-6
User Programming
<KX-T7200 series>
Press Soft 1 (SKP+) or VOLUME
<KX-T7400 series>
Rotate the Jog Dial clockwise.
• To go to the next smaller program address:
<KX-T7200 series>
Press SHIFT + Soft 1 (SKP–) or VOLUME
<KX-T7400 series>
Rotate the Jog Dial counterclockwise.
To go to a specific program address:
Press END, then enter the program address.
(DOWN).
(UP).