Panasonic KX-TD500 User Manual page 193

D
• DISA built-in Automated Attendant Tables
This system can store up to eight DISA built-in auto attendant number tables, each
includes 10 one-digit numbers.
• DISA built-in Automated Attendant Number
The DISA built-in auto attendant number may be the same as the first digit of other
numbers (extension number, Floating Number, etc.). To avoid confusion, the system
waits for the second digit for a pre-programmed amount of time (default: 1 second). If
the second digit is not dialed until the timer expires, the system assumes that the first
digit is a DISA built-in auto attendant number.
• Call Forwarding-to CO or TIE Line
If a DISA call is forwarded to an outside party, the caller is not required to enter a
DISA user code if the DISA security mode is "Non Security" or "Trunk Security."
• CO-to-CO line call duration
The duration of CO-to-CO line calls can be limited by System Programming. When
the specified time expires (default:10 min), both lines are disconnected unless the caller
prolongs the duration time, if available. A warning tone is sent to both parties 15
seconds before the time-limit at 5-second intervals.
• Prolonging the CO-to-CO line call is possible. To prolong his/her call, the caller should
press any dialpad key except
Time" (0 to 7 minutes). (If this is set to zero, then prolonging is disabled.) Depending
on "(13) DISA Prolong Operation", the call can be prolonged ten times or without limit.
• To detect the end of a CO-to-CO line call, CPC Signal Detection and Tone Detection
can be assigned.
• DISA Call Re-try by Pressing
The " " key can be entered during a DISA call. The action taken by the system
depends upon System Programming (System Option 2/4, (14) ' Dialing " " in DISA
CO-to-CO talking
will disconnect the current call and prepare for a new call. Otherwise, the
transmitted down the line to the other party.
• Intercept Routing
The Floating Number of a DISA OGM Group can be selected as the destination of
Intercept Routing.
• What if the destination extension is busy?
If the destination extension has enabled Call Waiting, then he or she will hear the Call
Waiting tone. Otherwise, the caller may hear a busy tone, or the call is redirected to the
IRNA destination. This is determined by System Programming (Section 4.2.7 System-
System Option, "(17) Destination Busy-DISA" in the Installation Manual).
• What if an illegal number is dialed?
The caller may hear a reorder tone, or the call is redirected to the IRNA destination.
This is determined by System Programming (Section 4.2.7 System-System Option,
"(21) Illegal Number-DISA" in the Installation Manual).
4-78
Station Features and Operation
4.3 Station Features and Operation
,
). If "Disconnect and make a new call" is selected, then the system
. The amount of prolonging is set by "DISA Prolong
will be