Panasonic KX-TD500 User Manual page 89

2.2
— Using the Jog Dial (With a KX-T7431 / KX-T7433 / KX-T7436 only)
See Combination Table 2.
1. Press 6 and then rotate the Jog Dial one pulse to enter "M".
2. Press 4 and then rotate the Jog Dial six pulses to enter "i".
3. Press 5 and then rotate the Jog Dial four pulses to enter "k".
4. Press 3 and then rotate the Jog Dial four pulses to enter "e".
OR
1. Press 2 and then rotate the Jog Dial until "M" appears.
2. Press 2 and then rotate the Jog Dial until "i" appears.
3. Press 2 and then rotate the Jog Dial until "k" appears.
4. Press 2 and then rotate the Jog Dial until "e" appears.
Notes
• Pressing the SHIFT button alternates between capital and lower case letters. Once this
button is pressed, that letter SHIFT mode remains until SHIFT is pressed again.
• To erase the last word (to backspace), press the CONF button.
(The CONF button becomes the "
• To erase all of the data, press the CLR (S2) button.
• If you keep rotating the Jog Dial, all of the characters will be displayed in order.
<Example> If you rotate the Jog Dial after pressing 2, all of the characters will appear
in the following order:
A a B b ···· Z z (space) ! ? . , ' : ;
B b ····
Conditions
• The default is "Not Stored".
• Up to 10 dialing numbers and names can be assigned. Each dialing number has a
maximum of 16 digits and each name has a maximum of 10 characters.
• The number can be an extension number, telephone number or a feature number.
• To store the telephone number of an outside party, a line access code (9, or 801
through 848) must be stored as the leading digit.
• You can use 0 through 9,
FLASH : hook flash
PAUSE : pause
CONF
INTERCOM : for secret dialing
2-48
Station Programming
Station Programming
" (backspace) key when using the overlay.)
, #, PAUSE, FLASH, CONF and INTERCOM for storing.
: — (hyphen)
/ + – = < > # $ % & @ ( ) A a