Troubleshooting
Error reading USB hub. Remove hub.
An unsupported USB hub has been inserted. Remove the USB hub, and then install a supported one.
If restarting job, replace originals that have not begun to exit the scanner
Try one or more of the following:
•
Touch Cancel job to clear the message and cancel the scan job.
•
Touch Scan from automatic feeder to continue scanning from the ADF immediately after the last successful scan
job.
•
Touch Scan from flatbed to continue scanning from the scanner immediately after the last successful scan job.
•
Touch Finish job without further scanning to end the last successful scan job.
•
Touch Restart job to restart the scan job with the same settings from the previous scan job.
Insert staple cartridge
Try one or more of the following:
•
Insert a staple cartridge.
•
Touch Continue to clear the message and print without using the staple finisher.
Insert Tray [x]
Insert the specified tray into the printer.
Install bin [x]
Try one or more of the following:
•
Install the specified exit bin:
1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Install the specified exit bin.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.
•
Cancel the print job.
Install duplex
Try one or more of the following:
•
Install the duplex unit:
1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Install the duplex unit.
265