Lexmark 6500e User Manual page 184

Understanding printer menus
Menu item
Location
Alarms
Alarm Control
Cartridge Alarm
Staple Alarm
Timeouts
Standby Mode
1–240
Disabled
Timeouts
Sleep Mode
1–240 min
Disabled
Timeouts
Screen Timeout
15–300 sec
Timeouts
Print Timeout
Disabled
1–255 sec
Description
Specifies the location of the scanner
Note: The location will be stored on the Embedded Web Server.
Sets an alarm to sound when the scanner or printer requires user
intervention
Available selections for each alarm type are:
Off
Single
Continuous
Notes:
•
Single is the factory default setting for Alarm Control. Single
sounds three quick beeps.
•
Off is the factory default setting for Cartridge Alarm. Off
means no alarm will sound.
•
Continuous repeats three beeps every 10 seconds.
Specifies the number of minutes of inactivity before the system
enters a lower power state
Note: 15 is the factory default setting.
Sets the amount of time the scanner waits after a job is printed
before it goes into a reduced power state
Notes:
• "30 min" is the factory default setting.
•
Disabled appears only when Energy Conserve is set to Off.
•
Lower settings conserve more energy, but may require
longer warm‑up times.
•
Select a high setting if the printer is in constant use. Under
most circumstances, this keeps the printer ready to print
with minimum warm‑up time.
Sets the amount of time in seconds the scanner waits before
returning the display to a ready state
Note: "30 sec" is the factory default setting.
Sets the amount of time in seconds the scanner waits to receive an
end‑of‑job message before canceling the remainder of the print job
Notes:
•
"90 sec" is the factory default setting.
•
When the timer expires, any partially printed page still in the
printer is printed, and then the scanner checks to see if any
new print jobs are waiting.
•
Print Timeout is available only when using PCL emulation.
This setting has no effect on PostScript emulation print jobs.
184