Not Enough Free Space In Flash Memory For Resources; Standard Network Software Error - Lexmark 6500e User Manual

Troubleshooting

52 Not enough free space in flash memory for resources

Try one or more of the following:
•
Touch Continue to clear the message and continue printing.
Downloaded fonts and macros not previously stored in flash memory are deleted.
• Delete fonts, macros, and other data stored in flash memory.
• Upgrade to a larger capacity flash memory card.
54 Network [x] software error
Try one or more of the following:
•
Touch Continue to continue printing.
• Turn the printer off, wait for about 10 seconds, and then turn the printer back on.
• Upgrade (flash) the network firmware in the printer.
54 Serial option [x] error
Try one or more of the following:
•
Make sure the serial cable is connected properly and is the correct one for the serial port.
•
Make sure the serial interface parameters (protocol, baud, parity, and data bits) are set correctly on the scanner
and host computer.
•
Touch Continue to clear the message.
•
Turn the scanner power off and then back on to reset the scanner.

54 Standard network software error

Try one or more of the following:
•
Touch Continue to continue printing.
•
Turn the printer off and then back on to reset the printer.
•
Upgrade (flash) the network firmware in the printer or print server.
55 Unsupported option in slot [x]
1
Turn the scanner off.
2
Unplug the power cord from the wall outlet.
3
Remove the unsupported option card from the scanner system board, and then replace it with a supported card.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the scanner back on.
275