Lexmark 6500e User Manual page 169

Understanding printer menus
Menu item
ENA gateway
yyy.yyy.yyy.yyy
Serial [x] menu
Menu item
PCL SmartSwitch
On
Off
PS SmartSwitch
On
Off
NPA Mode
Auto
On
Off
Description
Sets the gateway information for an external print server
Note: This menu appears only when the scanner is attached to an external print
server through the USB port.
Description
Sets the scanner to automatically switch to PCL emulation when a print job received
through a serial port requires it, regardless of the default printer language
Notes:
• On is the factory default setting.
•
When set to Off, the scanner does not examine incoming data. The scanner
uses PostScript emulation if PS SmartSwitch is set to On. It uses the default
printer language specified in the Setup menu if PS SmartSwitch is set to Off.
Sets the scanner to automatically switch to PS emulation when a print job received
through a serial port requires it, regardless of the default printer language
Notes:
•
On is the factory default setting.
• When set to Off, the scanner does not examine incoming data. The scanner
uses PCL emulation if PCL SmartSwitch is set to On. It uses the default printer
language specified in the Setup menu if PCL SmartSwitch is set to Off.
Sets the scanner to perform the special processing required for bidirectional
communication following the conventions defined by the NPA protocol
Notes:
•
Auto is the factory default setting. Auto sets the scanner to examine data,
determine the format, and then processes it appropriately.
•
When set to On, the scanner performs NPA processing. If the data is not in
NPA format, it is rejected as bad data.
•
When set to Off, the scanner does not perform NPA processing.
•
Changing this setting from the scanner control panel and then exiting the
menus causes the scanner to restart. The menu selection is then updated.
169