Checking The Total Counter; Counter Report Print Out; Type Of Paper - Oce OP30C Operation Manual

Section 7 COPIER MANAGEMENT

# Checking the total counter

Use the M cursor or the N cursor key to select the type of
1
copies that you want to check the count for.
Inch specifications
Metric specifications
2 Use the M cursor key to select "End" and then press the
Enter key.
NOTE
The total counter can also be checked using the following procedure.
1 Press the */Language key for approximately 5 seconds.
The verification screen for the total counter will appear.
Use the M cursor or the N cursor key to select the type of copies
that you want to check the count for.
2 After you are finished checking the total counter, use the M cursor
key to select "End" and then press the Enter key.
7-31

$ Counter report print out

1 Make sure that 11" x 8
the drawers.
* If a Memory Copy Board is installed in your copier, make
sure that 8 " x 11" or 11" x 8
1/2
loaded in one of the drawers. (8
can be loaded into the optional Paper Feeder.)
2 Use the M cursor or the N cursor key to select which report
you want to print out.
Inch specifications
Metric specifications
3
Press the Enter key.
The selected report will be printed out.
4 Use the M cursor key to select "z End" and then press the
Enter key.

%Type of paper

Use the M cursor or the N cursor key to select the type of
1
paper that is loaded in each drawer.
* The "Paper Type 1st Cassette" ["PAPER TYPE (1ST)"]
drawer setting is not available in duplex copiers.
Inch specifications
Metric specifications
2 Press the Enter key.
" [A4] size paper is loaded in one of
1/2
" [A4 or A4R] size paper is
1/2
" x 11" and A4R paper
1/2