Oce OP30C Operation Manual page 110

Section 7 COPIER MANAGEMENT
Default setting
* Insert tray
Sets the drawer that contains the paper which will be
fed in the insert sheet modes (page 6-26).
* No.3 and No.4 drawers can only be selected when
( Sort mode ON/OFF
Sets the default setting for the sort mode at the time
(Output form) power is turned on.
) Eject destination
Sets the location for ejection of finished copies: the
copy eject tray (side) or the copy storage table
(inner).
⁄ ACS adjustment
Adjusts the level of detection between color and
black&white originals in the Auto Color Selection
mode (page 4-1).
¤ Auto color
Slight changes in color copying may take place if
adjustment your color copier is used over a long period of time.
If the color on the originals and that which appears
on the copies begins to differ greatly, use this
procedure to adjust the color.
‹ Drum refresh
This operation should be performed when high
humidity causes the copy image to become blurred
or faded. The operation will take approximately 5
minutes.
› Rotate sort ON/OFF
Selects between standard sorting (page 6-46) or
rotate-sorting (page 6-46) as the default sort mode
whenever the sort mode is selected.
* In order to use this setting, there must be
7-15
Description
the optional Paper Feeder is installed in your
copier.
11" x 8 and 8 " x 11" [B5 and B5R or A4 and
1/2 1/2
A4R] paper set in the drawers. (8
A4R paper can be loaded into the optional Paper
Feeder, while B5 paper can be set onto the multi-
bypass tray. However, 2-sided copies cannot be
made automatically when paper is being fed from
the multi-bypass tray.)
Available settings
Standard copiers
1 paper [SOURCE 1] –
4 paper [SOURCE 4] /
Bypass
Duplex copiers
2 paper [SOURCE 2] –
4 paper [SOURCE 4] /
Bypass
On / Off
Inner Eject / Side Eject
1 – 5
---
---
On / Off
" x 11" and
1/2
Factory Reference
setting page
2 paper 7-21
[SOURCE 2]
Off 7-21
Inner Eject 7-22
1 7-22
--- 7-22
--- 7-23
Off 7-23