Accessing The Copy Management Procedures - Oce OP30C Operation Manual

Section 7 COPIER MANAGEMENT

(2) Accessing the copy management procedures

1
Press the */Language key.
The "Default mode setting" ["SELECT SET ITEM"] screen will
appear.
Inch specifications
2 Use the M cursor or the N cursor key to select "v Default".
Inch specifications
Metric specifications
3 Press the Enter key.
4 Use the numeric keys on the keypad to enter the 4-digit
management PIN code "3000".
Inch specifications
Metric specifications
NOTE
It is possible for you to change the 4-digit management PIN code.
(See "0 Management PIN code" on page 7-30.)
7-3
Metric specifications
5 Make sure that "x Management" is selected and press the
Enter key.
The "Copy Management" screen will appear.
Inch specifications
Metric specifications
NOTE
Refer to "(3) Performing copy management procedures" and perform
the desired procedure(s).