Oce OP30C Operation Manual page 80

Section 6 FUNCTIONS
Use the M cursor or the N cursor key to select the layout
2
mode that you want to use.
Inch specifications
Metric specifications
3 Press the Enter key.
4 Use the M cursor or the N cursor key to select the type of
the borderline that you want to use. Select either "x Solid",
"c Dotted", or "v Mark" ["v CROPMARK"]. If you do not
want to use a borderline to separate the images, select "z
None".
Inch specifications
Metric specifications
5 Press the Enter key.
6 Use the M cursor or the N cursor key to specify the type of
originals being copied.
Select "z 1-sided" if you are using 1-sided originals and
"x 2-sided" if you are using 2-sided originals.
Inch specifications
Metric specifications
7 Press the Enter key.
• If your machine is a duplex copier, go to the next step.
• If your machine is a standard copier, go directly to step 10.
6-33
Use the M cursor or the N cursor key to select the type of
8
finished copies you want to make.
Select "z 1-sided" if you want to make 1-sided copies and
"x Book/2-sided" ["x BOOK (2-SIDED)"] if you want to
make 2-sided copies. If you want to rotate the image on the
back side of a 2-sided copy, select "c Tablet/2-sided"
["c TOP BINDING"].
Inch specifications
Metric specifications
9 Press the Enter key.
10 Set the original to be copied.
NOTES
• Make sure that the originals are set in the proper order on the
platen.
• If necessary, select the location of paper feed.
11 Press the Start key. Scanning of the original will start.
• If you set the originals in the optional DF, copying will start
automatically.
• If you set the original on the platen, go to the next step.
12 Replace the first original with the next one and press the
Start key. Scanning of that next original will start.
Carry out this step for all of the originals that you want to
copy and, once you have finished scanning them all, press
the Enter key. Copying will start.