Status Report Print Out; Auto Drawer Switching On/Off; Auto Shut-Off On/Off; Special Paper Location - Oce OP30C Operation Manual

1 Status report print out

1 Make sure that 11" x 8
the drawers.
* If a Memory Copy Board is installed in your copier, make
sure that 8 " x 11" or 11" x 8
1/2
loaded in one of the drawers. (8
can be loaded into the optional Paper Feeder.)
2 Press the Enter key.
The status report will be printed out.

2 Auto drawer switching ON/OFF

1 Use the M cursor or the N cursor key to select either "z On"
or "x Off".
Inch specifications
Metric specifications
2 Press the Enter key.

3 Auto shut-off ON/OFF

Use the M cursor or the N cursor key to select either "z On"
1
or "x Off".
Inch specifications
Metric specifications
2 Press the Enter key.
" [A4] size paper is loaded in one of
1/2
" [A4 or A4R] size paper is
1/2
" x 11" and A4R paper
1/2
Section 7 COPIER MANAGEMENT

4 Special paper location

Use the M cursor or the N cursor key to select the location
1
(a drawer or the multi-bypass tray) where recycled or special
paper will be loaded.
* The "1 paper" ["SOURCE 1"] drawer is not available in
duplex copiers.
Inch specifications
Metric specifications
Press the P cursor key. An asterisk (
2
the selected location.
If you want to cancel the designation, press the O cursor key
and the asterisk will be deleted.
Inch specifications
Metric specifications
3 Use the M cursor or the N cursor key to select "End" and
then press the Enter key.
) will appear next to
7-28