Oce OP30C Operation Manual page 121

Default setting
0 Management PIN
Changes the PIN code that is needed to access the
code copy management procedures (page 7-1), copy
default settings (page 7-12) and these machine
default settings (page 7-24).
* If you do change the PIN code, be sure to make
some sort of note of the new one. If you happen to
forget it, enter the PIN code "6482".
! Silent mode
The copier can be switched to a silent mode, which
ON/OFF shuts down the motor inside the copier immediately
after each copy job is finished. If you select to turn
the silent mode ON, the motor will be stopped
immediately after copying is completed.
@ Day & time
Set the current date and time and other related
settings.
* Be ABSOLUTELY certain to set the correct time,
or certain functions of the copier may not operate
properly.
# Checking the total
Perform this procedure when you want to check the
counter total number of black and white copies, mono-color
copies and full color copies made.
NOTE:
The total counter can also be checked using the
following procedure.
1 Press the */Language key for approximately
2 After you are finished checking the total counter,
$ Counter report print
Prints out reports on toner usage for each of the
out copy, printer and fax functions of this machine.
% Type of paper
Sets the type of paper that is loaded in each
drawer.
* Setting is possible for drawers No.1 through No.4
in standard copiers and drawers No.2 through
No.4 in duplex copiers.
Description
5 seconds.
The verification screen for the total counter will
appear.
Use the M cursor or the N cursor key to select
the type of copies that you want to check the
count for.
use the M cursor key to select "End" and then
press the Enter key.
Section 7 COPIER MANAGEMENT
Available settings Factory setting
----- 3000
On / Off Off
----- -----
----- -----
----- -----
PLAIN PLAIN
REPRINTED
RECYCLED [RECYCLE]
VELLUM
ROUGH
LETTERHEAD
COLOR [COLOUR]
PREPUNCHED
Custom Size 1 – 8
Reference
page
7-30
7-30
7-30
7-31
7-31
7-31
7-26