Custom Erase Size; Insert Tray; ( Sort Mode On/Off (Output Form) - Oce OP30C Operation Manual

Section 7 COPIER MANAGEMENT
& Custom erase size
Press the O cursor or the P cursor key to select the length
1
of the original to be used in the custom erase mode.
(The length can be set to any 5/16" increment between
3 " and 8 " [any 8 mm increment between 94 mm and
11/16 7/16
214 mm.])
Inch specifications
Metric specifications
2 Press the N cursor key to change to the width size setting.
3 Press the O cursor or the P cursor key to select the paper
width. (The length can be set to any 1/8" increment between
2 " and 11 " [any 4 mm increment between 60 mm and
3/8 5/8
296 mm.])
Inch specifications
Metric specifications
4 Press the Enter key.
7-21

* Insert tray

Use the M cursor or the N cursor key to select the drawer
1
that contains the paper which will be fed in the insert sheet
modes.
* The "1 paper" ["SOURCE 1"] drawer is not available in
duplex copiers.
Inch specifications
Metric specifications
2
Press the Enter key.

( Sort mode ON/OFF (Output form)

1 Use the M cursor or the N cursor key to select either
"z On" or "x Off".
Inch specifications
Metric specifications
2 Press the Enter key.