Oce OP30C Operation Manual page 120

Section 7 COPIER MANAGEMENT
Default setting
5 APS for special
Sets whether the paper loaded in the drawer that
paper ON/OFF was selected under "4 Special paper location" on
page 7-28 will be used or not in the auto paper
selection mode or in automatic drawer switching
(page 2-5).
6 Color copy paper
Sets the location (a drawer or the multi-bypass tray)
location where paper will be loaded for color copying. When
you make color copies in the auto paper selection
mode, copying will be performed onto paper that is
loaded in the drawer that you select here.
* No.3 and No.4 drawers can only be selected
7 Auto preheat time
Sets the amount of time between the point that
copying ends and the energy-saving preheat mode
(page 6-47) engages.
8 Auto shut-off time
Sets the amount of time that will elapse if no
operation is performed before the auto shut-off
function (page 6-48) engages and turns the copier
OFF (
shut-off function. If the auto shut-off function is
turned OFF, this setting will not be effective. (See
"3 Auto shut-off ON/OFF" on page 7-28.)
The factory default time is 30 minutes.
* It is recommended that you try to set a longer time
* In order to disable the auto shut-off function, see
9 Display contrast
Adjusts the contrast of the LCD display if you
adjustment cannot see the message display clearly.
7-25
Description
when the optional Paper Feeder is installed in
your copier.
). It is also possible to disable the auto
interval before auto shut-off engages if you use
the copier frequently, and to a shorter time if it is
used less frequently.
"3 Auto shut-off ON/OFF" on page 7-28.
Available settings Factory setting
On / Off On
Standard copiers -----
Bypass /
1 paper [SOURCE 1] –
4 paper [SOURCE 4]
Duplex copiers
Bypass /
2 paper [SOURCE 2] –
4 paper [SOURCE 4]
5 minutes – 45 minutes 15 minutes
(5 minute increments)
15 minutes – 240 30 minutes
minutes (15 minute
increments)
1 – 7 4 (middle setting)
Reference
page
7-29
7-29
7-29
7-29
7-30