Link Status (Menu) - Comtech EF Data DMD-2050E Installation And Operation Manual

DMD2050E Universal Satellite Modem
MONITOR MENU
CORRECTED BER
VOLTAGES (Menu)
RX BUFFER LEVEL
RX BUFFER RESET (ENTER)
RAW BER
BIT ERRORS
4.4.4.1

LINK STATUS (menu)

IMPORTANT
When the TERRESTRIAL INTERFACE parameter is ETHERNET, these additional
status items are visible. See also
TOTAL PACKETS Displays the total number of Ethernet packets received from the satellite
ERROR PACKETS Displays the number of erred Ethernet packets received from the satellite
PKT ERROR RATE Displays the satellite Packet Error Rate
PKT STATS RESET Press ENTER to reset the Ethernet packet statistics.
JS1 PORT Displays the current status of LAN Port 1. See Note.
JS2 PORT Displays the current status of LAN Port 2. See Note.
JS3 PORT Displays the current status of LAN Port 3. See Note.
JS4 PORT Displays the current status of LAN Port 4. See Note.
WAN STATUS Displays the current status of the WAN Port. See Note.
MN-DMD2050E Revision 2
The CBER display shows an estimated corrected bit error rate of the modem.
Depending on the symbol rate the modem is running, the high-end
performance scale of this display will vary (10 E
symbol rates, a better than scale reading will appear as 0.0 x 10
symbol rates, it will appear as E**. In either case, they both mean performance
is better than the scale upper limit.
See VOLTAGES (menu)
{0 – 100%}
Displays the status of the Doppler Buffer.
Press ENTER to re-center the Doppler Buffer.
Displays the estimated channel error rate (before decoding) measured by the
modem. (Viterbi and Trellis only)
Displays the current error count from the Viterbi Decoder.
(NOT DISPLAYED FOR TPC OR LDPC MODES)
TX SETUP (menu)
User Interfaces
, 10 or 10 ). At some
-9 -10 -11
. At other
-00
or RX SETUP (menu).
4–25