Cnc (Menu); Ita (Menu) - Comtech EF Data DMD-2050E Installation And Operation Manual

DMD2050E Universal Satellite Modem
4.4.2.6

CNC (menu)

IMPORTANT
When the Carrier-in-Carrier
Enable/Disable {Enabled, Disabled}
MIN SRCH DELAY {Minimum Search Delay (ms), 0 to Max}
MAX SRCH DELAY {Maximum Search Delay (ms), Min to 330ms}
FREQ OFFST RNG {Range of Frequency Offset (KHz) between the
Interferer and the desired received signal.
(+/- 1Khz to +/- 32Khz)}
4.4.2.7

ITA (menu)

IMPORTANT
When the EBEM Network Specification is selected these parameters are available.
ITA Option {DISABLED, ENABLED}
BPSK 1/2 {NOT SELECTED, SELECTED}
BPSK 2/3 {NOT SELECTED, SELECTED}
BPSK 3/4 {NOT SELECTED, SELECTED}
BPSK 7/8 {NOT SELECTED, SELECTED}
BPSK 19/20 {NOT SELECTED, SELECTED}
QPSK 1/2 {NOT SELECTED, SELECTED}
QPSK 2/3 {NOT SELECTED, SELECTED}
QPSK 3/4 {NOT SELECTED, SELECTED}
QPSK 7/8 {NOT SELECTED, SELECTED}
QPSK 19/20 {NOT SELECTED, SELECTED}
8PSK 1/2 {NOT SELECTED, SELECTED}
8PSK 2/3 {NOT SELECTED, SELECTED}
8PSK 3/4 {NOT SELECTED, SELECTED}
8PSK 7/8 {NOT SELECTED, SELECTED}
8PSK 19/20 {NOT SELECTED, SELECTED}
16APSK 1/2 {NOT SELECTED, SELECTED}
16APSK 2/3 {NOT SELECTED, SELECTED}
16APSK 3/4 {NOT SELECTED, SELECTED}
16APSK 7/8 {NOT SELECTED, SELECTED}
16APSK 19/20 {NOT SELECTED, SELECTED}
ITA MARGIN 0.00 .. 2.00 dBm
ITA HYSTERESIS 0.00 .. 2.00 dBm
MN-DMD2050E Revision 2
option is installed, these parameters are available.
®
User Interfaces
Enable or disable the CnC.
Enable or disable the ITA Function.
Used to select the mod/code rate
Used to select the mod/code rate
Used to select the mod/code rate
Used to select the mod/code rate
Used to select the mod/code rate
Used to select the mod/code rate
Used to select the mod/code rate
Used to select the mod/code rate
Used to select the mod/code rate
Used to select the mod/code rate
Used to select the mod/code rate
Used to select the mod/code rate
Used to select the mod/code rate
Used to select the mod/code rate
Used to select the mod/code rate
Used to select the mod/code rate
Used to select the mod/code rate
Used to select the mod/code rate
Used to select the mod/code rate
Used to select the mod/code rate
Sets the ITA link margin (added to the
default entry in Es/No
Sets the ITA hysteresis used to
overlap the ITA switching point
4–18