Installation Safety; Installation Considerations - Comtech EF Data DMD-2050E Installation And Operation Manual

DMD2050E Universal Satellite Modem
2.2

Installation Safety

The unit is shipped fully assembled. Do not remove the covers when you install the unit.
WARNING
SHOCK HAZARD - There are no user-serviceable parts or configuration settings
inside the DMD2050E chassis. There is a shock hazard at the internal power supply
module. DO NOT open the DMD2050E chassis under any circumstances.
WARNING:
DANGER OF EXPLOSION if you replace the battery incorrectly. The unit contains a
Lithium Battery. Replace the battery with the same or equivalent battery as
recommended by the manufacturer.
CAUTION
Protect existing communication traffic. Before you connect power and start the unit,
disconnect the transmit output from the operating ground station equipment.
CAUTION: CORRECT GROUNDING PROTECTION REQUIRED
Always make sure the ground stud on the rear panel of the unit is connected to
protective earth. Correct grounding protection helps prevent personal injury and
equipment damage.
In Finland: "Laite on liitettävä suojamaadoituskoskettimilla varustettuun pistorasiaan."
In Norway: "Apparatet må tilkoples jordet stikkontakt."
In Sweden: "Apparaten skall anslutas till jordat uttag."
2.3

Installation Considerations

•
•
•
•
MN-DMD2050E Revision 2
Do not install rack slides on the sides of the chassis. Rack slides block airflow
to the cooling fans inside the unit.
Make sure that there is sufficient space for airflow at the sides of the unit.
In racks where heat is high, make sure to install forced air cooling at the top or
bottom of the rack.
Do not let the temperature inside the rack exceed 50°C (122°F).
Installation
2–2