Chery Tiggo 2009 Service Manual page 1311

1. Raise and support the vehicle.
2. Remove the wheel mounting nuts and the wheel assembly.
(Tighten: Wheel mounting nuts to 110 N·m)
3. Remove the bolt (1) between the control arm and
the sub-frame.
(Tighten: Control
180 ± 10 N·m)
4. Remove the nut (1) between the control arm and
the steering knuckle.
(Tighten: Control arm to steering knuckle nut to
120 ± 10 N·m)
5. Remove the bolt (1) between the rear rubber
sleeve of the control arm and the sub-frame.
(Tighten: Rear rubber sleeve control arm to sub-
frame bolt to 180 ± 10 N·m)
6. Remove the control arm from the vehicle.
7. Perform the following inspection procedure before installation.
10
10–
ON-VEHICLE SERVICE
arm to sub-frame bolt to
Chery Automobile Co., Ltd.
LTSM100055
LTSM100006
LTSM100057