Automatic Transaxle On-Vehicle Service; Dpo Automatic Transaxle Assembly Removal & Installation - Chery Tiggo 2009 Service Manual

DPO Automatic Transaxle Assembly
Removal & Installation
1. Raise and support the vehicle.
2. Remove the engine cover.
3. Remove the battery and battery tray (See Battery Removal & Installation in Section 05 Starting & Charging).
4. Remove the air cleaner and air duct assembly.
5. Drain the cooling system (See Cooling System Draining Procedure in Section 06 Cooling System).
6. Remove the base mounting (1) of the air cleaner
housing assembly.
7. Remove the transaxle ground cable.
8. Disconnect and remove the electrical connectors
for the following components:
• Vehicle speed sensor (2)
• Crankshaft position sensor
• Automatic transaxle assembly (3)
9. Disconnect the transaxle fluid coolant lines (4)
using a suitable tool.
10. Remove the shift cable (1) from the transaxle
assembly.
11. Raise the vehicle.
12. Remove the drain plug (2) with an inner square
socket wrench.
13. Remove the fluid limiting duct (1) with an 8 mm
inner hex socket wrench.
14. Drain the transaxle fluid.
136
08–
ON-VEHICLE SERVICE
Chery Automobile Co., Ltd.
LTSM050002
BESM080057
LTSM080184