Door Lock Assembly Inspection - Chery Tiggo 2009 Service Manual

14. Remove three door lock assembly retaining bolts.
(Tighten: Door lock assembly retaining bolts to 9 ± 1 N·m)
15. Remove the internal unlock cable (1) and lock
cable (2).
16. Remove the lock buckle with a screwdriver.
(Tighten: Lock buckle screws to 12 ± 2 N·m)
17. Installation is in the reverse order of removal.

Door Lock Assembly Inspection

1. Using the following table, apply battery voltage to the specified connector terminals.
2. Verify that the door lock assembly operates in the lock and unlock position when voltage is applied to the spec-
ified terminals.
3. If the test results are not as specified, replace the motor.
MEASURING CONDITION
Battery positive (+) to terminal – 1
Battery negative (-) to terminal – 2
Battery positive (+) to terminal – 2
Battery negative (-) to terminal – 1
Chery Automobile Co., Ltd.
DOOR LOCKS
OPERATIONAL DIRECTION
LTSM150098
Lock
Unlock
15–
15
37