Chery Tiggo 2009 Service Manual page 1717

On Board Diagnostic Logic
• Self-diagnosis detection logic.
DTC NO.
B3055
B3056
DTC Confirmation Procedure:
Before performing the following procedure, confirm that battery voltage is more than 12 V.
• Turn ignition switch off.
• Connect the X-431 scan tool to the Data Link Connector (DLC) - use the most current software available.
• Turn the ignition switch on, with the scan tool, view and erase stored DTCs in the Immobilizer control module.
• Try to start the engine.
• Turn ignition switch off, and wait a few seconds, then turn the ignition switch on.
• With the scan tool, view active DTCs in the Immobilizer control module.
• If the DTC is detected, the condition is current. Go to Diagnostic Procedure - Step 1.
• If the DTC is not detected, the DTC condition is intermittent (See Diagnostic Help and Intermittent DTC Trou-
bleshooting in Section 15 Body & Accessories for more information).
NOTE :
While performing electrical diagnosis & testing, always refer to the electrical schematics for specific circuit
and component information.
Diagnostic Procedure
1.
CHECK GROUND CONNECTION
• Turn ignition switch off.
• Loosen and retighten ground screws on the body (See Ground Inspection in Section 15 Body & Accessories).
• Inspect ground connection C-204 mounting position (See Vehicle Wiring Harness Layout - Main Harness in
Section 16 Wiring).
Is the ground connection OK?
Yes >>
Go to the next step.
No >>
Repair or replace ground connection.
2.
CHECK IMMOBILIZER CONTROL MODULE DTC
• With the scan tool, view DTCs in the Immobilizer control module. Refer to DTC confirmation procedure.
Is DTC B3055 present?
Yes >>
Go to the next step.
No >>
The condition that caused the DTC to set is currently not present (See Diagnosis & Testing Diagnostic
Help in Section 15 Body & Accessories).
Chery Automobile Co., Ltd.
DIAGNOSIS & TESTING
DTC DETECTION
DTC DEFINITION
No transponder
modulation or no Ignition switch: ON
transponder
No transponder
fixed code Ignition switch: ON
programmed
DTC SET
CONDITION CONDITION
The Immobilizer
control module
detects no
transponder or no
transponder
modulation
condition.
The Immobilizer
control module
detects that the
transponder is not
programmed.
POSSIBLE CAUSE
• Transponder
• Harness or
connectors
• Immobilizer control
module
• Transponder
• Harness or
connectors
• Immobilizer control
module
15
133
15–