Check Shift Solenoid Valve 6 (Ssv6) Power Supply - Chery Tiggo 2009 Service Manual

Is the check result normal?
Yes >>
Replace the valve with a known good one.
With X-431, perform the solenoid actuate test.
− If the solenoid can be heard, go to step 6.
− If the solenoid can't be heard, go to the next step.
No >>
Replace the damaged solenoid valve.
4.

CHECK SHIFT SOLENOID VALVE 6 (SSV6) POWER SUPPLY

• Turn the ignition switch on.
• Check power supply between SSV6 E-037 terminal
B2 and ground in the A/T assembly connector
E-037.
• Battery voltage should exist.
• Or using the appropriate diagnostic test tool and a digital multimeter perform the following:
• Check the EVS6 solenoid supply voltage between TCM pin 1 and TCM pin 14 when activating the EVS6 sole-
noid and deactivating the EVS6 solenoid.
• Check the shift solenoid control signal. Check the voltage of the shift solenoid in each shift position.
• Check the voltage of the EVS6 solenoid supply circuit between the transaxle assembly electrical connector pin
B3 and pin B2.
LEVER
EVS1
POSITION
1 - 10
R 0 V
N/P 0 V
1 0 V
2 0 V
3 0 V
4 +12 V
Is the check result normal?
Yes >>
Go to the next step.
No >>
Repair or replace open circuit or short to ground in harness or connectors.
Chery Automobile Co., Ltd.
DIAGNOSIS & TESTING
SEQUENCE SOLENOID (EVS) CONDITION
TCM TERMINAL
EVS2 EVS3
1 - 9 1 - 7
0 V 0 V
0 V +12 V
0 V +12 V
+12 V 0 V
0 V 0 V
+12 V 0 V
EVS4 EVS5
1 - 8 1 - 13
0 V 0 V
0 V 0 V
+12 V 0 V
+12 V 0 V
0 V 0 V
0 V 0 V
LTSMD080044
08
EVS6
1 - 14
0 V
0 V
0 V
0
0 V
0 V
117
08–