Automatic Shifter Selector Removal & Installation (F4A4) - Chery Tiggo 2009 Service Manual

Installation Notes:
• Check the transaxle fluid level.
− Drive the vehicle until the ATF reaches oper-
ating temperature (70° - 80°C).
− Park the vehicle on level ground.
− Shift the gear selector lever to all gear posi-
tions once, then shift to gear "N".
− Clean and check the outside of the dipstick
and remove the dipstick to check the fluid
level.
− Check if the transmission fluid level is within
the HOT marking of the dipstick. If lower than
the HOT marking, refill the transaxle until the
fluid level is above the HOT marking.
• After installation, check for any fluid leakage and
verify the transaxle fluid level is correct. Refill the
transaxle fluid through the fill hole (1) shown in the
figure.
Automatic Shifter Selector
Removal & Installation
1. Raise and support the vehicle.
2. Disconnect the negative battery cable.
3. Remove the air cleaner and air duct assembly.
4. Remove the base mounting of the air cleaner housing assembly.
Chery Automobile Co., Ltd.
ON-VEHICLE SERVICE
08
LTSM080185
243
08–