Throttle Control Actuator Description (2.4L); Throttle Control Actuator Removal & Installation (2.4L); Operation - Chery Tiggo 2009 Service Manual

Throttle Control Actuator
Description
The throttle body is located on the intake manifold. The throttle body meters air into the intake manifold.
Throttle control actuator consists of throttle control valve, throttle position sensor, idle air control motor, etc.

Operation

Filtered air from the air cleaner enters the intake manifold through the throttle body. A throttle valve (plate) is used to
supply air for idle and driving conditions. The throttle position sensor is part the throttle body. The throttle position
sensor signal is used by the ECM to determine throttle position. The ECM controls the throttle control to meter air
into the engine. This regulates engine power. The vehicle is in sense a "Drive by Wire" system.
Removal & Installation
1. Remove the engine cover.
2. Disconnect the negative battery cable.
3. Disconnect the throttle position sensor and idle air control motor electrical connect on the throttle control actua-
tor.
4. Remove the accelerator cable on the throttle control actuator.
5. Remove three hoses on the throttle control actuator.
6. Remove four throttle control actuator mounting
bolts (1).
(Tighten: Throttle control actuator bolts to 10 N·m)
7. Remove the throttle control actuator and gasket carefully.
8. Installation is in the reverse order of removal.
NOTE :
Replace a new throttle control actuator gasket when installing.
538
03–
ON-VEHICLE SERVICE
Chery Automobile Co., Ltd.
LTSM030010