Chery Tiggo 2009 Service Manual page 1804

4. Replace the clamping piece if necessary:
• Remove the stopper with a knife.
• Remove the old clamping piece.
• Replace with a new clamping piece.
5. Position the glass:
• Place the glass in the proper position.
• Make reference marks on the glass and the
body.
• Remove the glass.
6. Clean the contact surface of the glass:
• Clear any residue around the peripheral con-
tact face of the glass with glass cleaner.
NOTE :
Do not touch the glass surface after cleaning.
7. Install the water resistance piece:
• Install the water resistance piece using double-sided adhesive tape as shown in the figure.
8. Apply a layer of primer M on the contact surface of
the body and apply a layer of primer M on the con-
tact face of the body with a brush.
NOTE :
Allow the primer coat to dry for a minimum of 3 minutes. Do not apply the primer to the bonding agent. Do not save
the opened primer M for later use.
9. Apply a layer of primer G on the contact surface of the glass:
• Apply a layer of primer G on the edges and the contact surface of the glass with a brush or sponge.
• Wipe the excess primer off with a clean rag before it dries.
NOTE :
Allow the primer coat to dry for a minimum of 3 minutes. Do not apply the primer to the bonding agent. Do not save
the opened primer G for later use.
10. Mixing the bonding agent:
• Clean a mixing board and a scraper completely with solvent.
• Thoroughly mix 500 grams of host crystal with 75 grams of hardener on a mixing board with a scraper.
NOTE :
Make sure that the molding is installed before the bonding agent has cured.
220
15–
STATIONARY GLASS
Primer M Primer M
Chery Automobile Co., Ltd.
BESM150015
Primer M
BESM150016