Check A/T Fluid Pressure Sensor Signal; Check Fluid Pressure Sensor Electrical Connector - Chery Tiggo 2009 Service Manual

Diagnostic Procedure
1.

CHECK A/T FLUID PRESSURE SENSOR SIGNAL

• With the scan tool, select view DTC and data stream for A/T.
• Start vehicle and monitor the value of INPUT SPEED SENSOR .
ITEM CONDITION
Ignition switch
on, not running
Fluid Pressure
• Engine: Idle
• TFT: 31°C
• ECT: 30°C
Is the check result normal?
Yes >>
The condition that caused this DTC is intermittent (See Diagnostic Help in Section 08 Transaxle &
Transfer Case).
No
>>
Go to the next step.
2.

CHECK FLUID PRESSURE SENSOR ELECTRICAL CONNECTOR

• Stop vehicle and turn ignition switch off.
• Disconnect fluid pressure sensor 2 connector.
• Inspect the electrical connector for damage.
Is the electrical connector OK?
Yes >>
Go to the next step.
No >>
Repair or replace the electrical connector
as necessary.
Chery Automobile Co., Ltd.
DIAGNOSIS & TESTING
DISPLAY
VALUE
Below 0.2 bar
Approximately
0.05 bar
08
LTSMD080021
101
08–