Blower Motor Resistor Removal & Installation - Chery Tiggo 2009 Service Manual

6. Loosen the two blend door and mode door control
cables (1).
7. Remove the manual temperature control module.
8. Installation is in the reverse order of removal.
Blower Motor Resistor
Removal & Installation
WARNING!
The blower motor resistor may get very hot during normal operation. If the blower motor was turned on prior to
servicing the blower motor resistor, wait five minutes to allow the blower motor resistors to cool before per-
forming diagnosis or service. Failure to take this precaution can result in possible personal injury.
CAUTION:
DON T operate the blower motor with the blower motor resistor removed from the circuit. Failure to
take this precaution can result in vehicle damage.
1. Disconnect the negative battery cable.
2. Remove the glove box (See Instrument Panel Removal & Installation in Section 15 Body & Accessories).
3. Disconnect the blower motor resistor electrical connector.
16
13–
ON-VEHICLE SERVICE
Chery Automobile Co., Ltd.
LTSM130001