NEL knob to select the operating channel you
want to communicate on, then press the
soft key. If the channel you want is
not shown, press the
rotate the CHANNEL knob to select the operating
channel you want to communicate on, then press
the
soft key.
6. Press the
signal.
7. When the Group Call signal is sent, the dis-
play will be as shown in the illustration at the
right.
8. After the Group Call is transmitted, all the ra-
dios in the group will switch to the designated chan-
nel.
9. Listen to the channel to make sure it is not busy,
then press the microphone's PTT switch and call
the other vessel you desire to communicate with.
9.7.2.2 Group Call by Manually Entering a MMSI
This feature allows you to contact a group of vessels by entering in their Group
MMSI manually.
1. Press the
pear.
2. Rotate the CHANNEL knob to select
"GROUP". (To cancel, press the
key.)
3. Press the
will beep, and the "Last Group Call" will ap-
pear.
MANUAL
4. Select "
5. Press the
6. Rotate the CHANNEL knob to select the first
number of the MMSI (nine digits: first digit per-
manently set to "0") which you want to con-
tact, then press the
the next number.
7. Repeat step 6 to set the MMSI number.
8. If a mistake was made entering in the MMSI
Page 62
soft key, then
soft key to transmit the Group Call
key. The "DSC Menu" will ap-
soft key. The transceiver
" with the CHANNEL knob.
soft key.
soft key to step to
soft
GX2000/GX2150