General Setup; Display - Standard Horizon GX2150 Owner's Manual

10 GENERAL SETUP

The optional RAM3 ( CMP30 ) Remote Station Microphone can also
change the SETUP menu using the following procedure.

10.1 DISPLAY

The GX2000/GX2150 can select additional screens other than the default
normal (Radio) display by using the procedure below.
"NORMAL" D
1. By default the COG in "NORMAL" and "COMPASS" displays and
BRG in "AIS", "COMPASS", and "WAYPOINT" displays are set to
"True", however this may be change to magnetic by following the
steps in section "10.9 MAGNETIC".
2. The "GPS STATUS" display is only available on the GX2150. For this
display to operate correctly, the GX2150 must be connected to a GPS
Chart plotter which outputs NMEA 0183 GSA and GSV sentences.
1. Press and hold down the
Menu" appears, then select "GENERAL SETUP" with
the CHANNEL knob.
2. Press the
NEL knob to select "DISPLAY".
3. Press the
4. Rotate the CHANNEL knob to select desired screen
type "NORMAL", "AIS", "COMPASS", "WAYPOINT", or
"GPS Status".
5. Press the
ting.
6. Press the
radio operation.
GX2000/GX2150
1
"AIS" D
ISPLAY
"WAYPOINT" D
ISPLAY
soft key, then rotate the CHAN-
soft key.
soft key to store the selected set-
soft key several times to return to
1
ISPLAY
"GPS STATUS" D
NOTE
key until "Setup
"COMPASS" D
ISPLAY
2
ISPLAY
1
Page 77