Nmea Data In/Out; Key Beep - Standard Horizon GX2150 Owner's Manual

10.10 NMEA DATA IN/OUT

This section is used to setup the NMEA 0183 baud rate of the GPS input (Blue
wire) and DSC output (Gray wire). The default setting is 4800 BPS. When
38400 BPS is selected the AIS sentences (VDM) and DSC sentences (DSC &
DSE) both are output on the Gray wire after a DSC Distress, Position Request
or AIS transmission is received. This Setup Menu works only in GX2150.
1. Press and hold down the
Menu" appears, then select "GENERAL SETUP" with
the CHANNEL knob.
2. Press the
NEL knob to select "NMEA DATA IN/OUT".
3. Press the
4. Rotate the CHANNEL knob to select the desired
baud rate.
5. Press the
rate.
6. Press the
dio operation.

10.11 KEY BEEP

This selection is used to select the beep tone volume level when a key is
pressed.
1. Press and hold down the
Menu" appears, then select "GENERAL SETUP" with
the CHANNEL knob.
2. Press the
NEL knob to select "KEY BEEP".
3. Press the
4. Rotate the CHANNEL knob to select the desired
level. The beep level can be set from "LEVEL 1" to
"LEVEL 6", "HIGH", or "OFF".
5. Press the
6. Press the
dio operation.
GX2000/GX2150
soft key, then rotate the CHAN-
soft key.
soft key to store the selected baud
soft several times to return to ra-
soft key, then rotate the CHAN-
soft key.
soft key to store the selected level.
soft several times to return to ra-
key until "Setup
key until "Setup
Page 83