Scanning; Scan Type Selection - Standard Horizon GX2150 Owner's Manual

5. Repeat steps 2 through 4 to delete the desired channels from Preset Chan-
nels "0" ~ "9".
6. To finish the deleting the Preset Channel, press the

8.10 SCANNING

The GX2000/GX2150 will automatically scan channels programmed into Pre-
set Channel Memory and also Scan Channel Memory, and last selected
Weather Channel.
When an incoming signal is detected on one of the channels during scan, the
radio will pause on that channel, allowing you to listen to the incoming trans-
mission. The radio will automatically start scanning again after the transmis-
sion stops.

8.10.1 Scan Type Selection

1. Press and hold down
Menu" appears.
2. Rotate the CHANNEL knob to select "CH
FUNCTION SETUP".
3. Press the
TYPE" with the CHANNEL knob.
4. Press the
5. Rotate the CHANNEL knob to select "PRIOR-
ITY SCAN" or "MEMORY SCAN".
6. Press the
ting.
7. Press the
Preset
Channel "5"
Preset
Channel "4"
Scan Memory
Channel
Preset
Channel "3"
"M
GX2000/GX2150
soft key, then select "SCAN
soft key.
soft key to store the selected set-
soft key several times to return to radio operation.
Preset
Channel "0"
Scan Memory
Channel
Channel "1"
Channel "2"
Scan Memory
Channel
Scan Memory
Channel
" S
EMORY CAN
key until "Setup
Preset
Channel "5"
Preset Preset
Channel "4"
Preset
Scan Memory
Channel
Preset
Channel "3"
soft key
Preset
Channel "0"
Scan Memory
Channel
Scan Memory
Channel
Scan Memory
Channel
"P " S
RIORITY CAN
Preset
Channel "1"
Preset
Channel "2"
Page 35