Receiving A Dsc Position Report Call; Navigating To A Position Report; Stop Navigating To Position Report - Standard Horizon GX2150 Owner's Manual

9.9.3 Receiving a DSC Position Report Call

When another vessel transmits their vessels location to the GX2000/GX2150
the following will happen:
1. A ringing sound will be produced when the call is received and NMEA
sentences DSC, DSE are outputted so the position
can be shown on a chart plotter or a computer.
2. Press the
3. Rotate the CHANNEL knob to see position infor-
mation of the station.
4. To exit to radio mode, press the

9.9.4 Navigating to a Position Report

The GX2000/GX2150 has a feature that allows navigation to a received Posi-
tion Report call by using the Compass display. Navigating to the position of a
Position Report call may be enabled by the procedure below.
1. After the Position Report call has been re-
ceived: press the
2. To start navigating using the compass display,
press and hold the
Compass Page is shown. The display indicates the
distance and direction of the received vessel, and
also the compass indicates the received vessel by
dot ( ) .
9.9.5 Stop Navigating to a Position Report
To stop navigation and return to the radio mode:
1. Press and hold down the
Menu" appears.
2. Rotate the CHANNEL knob to select "GENERAL
SETUP" menu.
3. Press the
with the CHANNEL knob.
4. Press the
5. Rotate the CHANNEL knob to select "NORMAL".
6. Press the
tion.
Page 70
key to stop ringing.
soft key.
soft key until the
soft key, then select "DISPLAY"
soft key.
soft key to return to radio opera-
soft key.
key until "Setup
GX2000/GX2150