Mounting The Radio; Supplied Mounting Bracket; Optional Mmb-84 Flush Mount Bracket - Standard Horizon GX2150 Owner's Manual

6.3

MOUNTING THE RADIO

6.3.1 Supplied Mounting Bracket

The supplied mounting bracket allows overhead or desktop mounting.
Use a 13/64" (5.2-mm) bit to drill the holes to a surface which is more 0.4 inch
(10 mm) thick and can support more than 3.3 lbs (1.5 kg) and secure the
bracket with the supplied screws, spring washers, flat washers, and nuts.
D

6.3.2 Optional MMB-84 Flush Mount Bracket

1. Use the supplied template to mark the location where the rectangular hole
is to be cut. Confirm the space behind the dash or panel is deep enough to
accommodate the transceiver (at least 6.7 inches (17 cm) deep).
There should be at least 1/2 inch (1.3 cm) between the transceiver's heatsink
and any wiring, cables or structures.
2. Cut out the rectangular hole and insert the transceiver.
3. Fasten the brackets to the
sides of the transceiver with
the lock washer screw combi-
nation; so that the mounting
screw base faces the mount-
ing surface.
4. Turn the adjusting screw to
adjust the tension so that the
transceiver is tight against the
mounting surface.
GX2000/GX2150
M
ESKTOP OUNTING
O
VERHEAD
Bracket
Lock-washer screw combination
M
OUNTING
Adjusting Screw
Page 13