Position Report; Position Report Ringer Setup; Transmitting A Dsc Position Report Call; Dsc Position Report Call Using The Individual Directory - Standard Horizon GX2150 Owner's Manual

9.9

POSITION REPORT

The feature is similar to Position Request, however instead of requesting a
position of another vessel this function allows you to send your position to
another vessel. Your vessel must have an operating GPS receiver connected
for the GX2000/GX2150 to send the position.
To transmit a Position Report Call, a GPS must be connected to the
radio and the GX2000 / GX2150 Individual directory must be programmed
with stations you wish to send your position to. To setup this directory
refer to section "9.5.1 Individual / Position Call Directory Setup".
9.9.1 Setting up a Position Report Ringer
The GX2000/GX2150 has the capability to turn off the Position Report ringer.
1. Press and hold down the
"Setup Menu" appears.
2. Rotate the CHANNEL knob to select "DSC
SETUP" menu.
3. Press the
BEEP" with the CHANNEL knob.
4. Press the
Report" with the CHANNEL knob.
5. Press the
with the CHANNEL knob.
6. Press the
ting.
7. Press the
radio operation.
To re-enable the ringer tone, repeat the above procedure, rotating the CHAN-
NEL knob to select "On" in step "5" above.

9.9.2 Transmitting a DSC Position Report Call

9.9.2.1 DSC Position Report Call using the Individual Directory

1. Press the
appear.
2. Rotate the CHANNEL knob to select "POS RE-
PORT". (To cancel, press the
3. Press the
4. Rotate the CHANNEL knob to select the name in
the directory, then press the
Page 68
NOTE
soft key, then select "DSC
soft key, then select "POS
soft key, then select "Off"
soft key to store the selected set-
soft key several times to return to
key. The "DSC Menu" will
soft key.
key until
soft key.)
soft key.
GX2000/GX2150