Standard Horizon GX2150 Owner's Manual page 18

GPS Connections ( GX2000: 4800 baud )
NMEA INPUT (GPS Information)
• The GPS must have the NMEA Output turned on and set to 4800 Baud in
the setup menu. If there is a selection for parity select none.
• For further information on interfacing /setting up your GPS. Please contact
the manufacturer of the GPS receiver.
• GX2000 can read NMEA-0183 version 2.0 or higher.
• The NMEA 0183 input sentences are GLL, GGA, RMC, and GNS (RMC
sentence is recommended).
NMEA Output (DSC)
The NMEA 0183 output sentences are DSC and DSE.
GPS Connections ( GX2150: 4800 baud or 38400 baud )
NMEA INPUT (GPS Information)
• The GX2150 can select the NMEA baud rate between "4800 bps" and
"38400 bps". Refer to section "10.10 NMEA DATA IN/OUT" for selection.
• For further information on interfacing /setting up your GPS, please contact
the manufacturer of the GPS receiver.
• GX2150 can read NMEA-0183 version 2.0 or higher.
• The NMEA 0183 input sentences are GLL, GGA, RMC, GNS, GSA, and
GSV (RMC sentence is recommended).
• NMEA Output (DSC)
The NMEA 0183 output sentences are DSC and DSE.
If 4800 baud (default) is selected:
a. The Gray wire of the GX2150 outputs DSC and DSE sentences
b. The Brown wire outputs AIS VDM sentence at 38400.
If 38400 baud is selected:
a. The Blue wire of the GX2150 input is at 38400 baud
b. The Gray wire of the GX2150 output is at 38400 baud and includes
both DSC (DSC, DSE) and AIS (VDM) sentences.
c. The brown wire does not change, it always outputs AIS sentences
at 38400 baud.
The GX2150 has a GPS status page which shows the signal strength
and locations of satellites. For the GX2150 to show the display correctly
a GPS must be connected and configured to output GSA and GSV NMEA
0183 sentences.
If you have further inquires, please feel free to contact Product Support at:
Phone: (800) 767-2450
Email: marinetech@vxstdusa.com
Page 18
NOTE
GX2000/GX2150