Position Request Ringer Setup; Transmitting A Position Request To Another Vessel; Position Request Using The Individual Directory - Standard Horizon GX2150 Owner's Manual

9.8.2 Position Request Ringer Setup

The GX2000/GX2150 has the capability to turn off the Position Request ringer.
1. Press and hold down the
"Setup Menu" appears.
2. Rotate the CHANNEL knob to select "DSC
SETUP" menu.
3. Press the
BEEP" with the CHANNEL knob.
4. Press the
Request" with the CHANNEL knob.
5. Press the
with the CHANNEL knob.
6. Press the
ting.
7. Press the
To re-enable the ringer tone, repeat the above procedure, rotating the CHAN-
NEL knob to select "On" in step "5" above.

9.8.3 Transmitting a Position Request to Another Vessel

9.8.3.1 Position Request using the Individual Directory

1. Press the
appear.
2. Rotate the CHANNEL knob to select "POS RE-
QUEST".
3. Rotate the CHANNEL knob to select a name
that was stored in the Individual DSC direc-
tory, then press the
4. Press the
sition Request DSC call.
5. When the GX2000/GX2150 receives the position
from the polled vessel it is shown on the ra-
dio display and also transferred to a GPS
Chart plotter with NMEA DSC and DSE sen-
tences.
6. Press the
tion.
If the GX2000/GX2150 does not receive a position data from the polled
vessel, the display will show "NO POSITION DATA."
GX2000/GX2150
soft key, then select "DSC
soft key, then select "POS
soft key, then select "Off"
soft key to store the selected set-
soft key several times to return to radio operation.
key. The "DSC Menu" will
soft key.
soft key to transmit the Po-
soft key to return to radio opera-
NOTE
key until
Page 65