Intercom Operation; Communication; Calling - Standard Horizon GX2150 Owner's Manual

8.12 INTERCOM OPERATION

To access the following Intercom functions one of the soft keys must be setup
as IC. Refer to section "10.14 SOFT KEYS".
In addition an optional RAM3 ( CMP30 ) Remote Station Microphone must be
connected to perform intercom functions between the GX2000/GX2150 and
the RAM3 ( CMP30 ) .

8.12.1 Communication

1. Press the one of the soft keys momentarily, then
press the
mode.
Note: Depending on the programming of the
soft key, the
soft key.
2. When the intercom mode is enabled, "Intercom" is displayed on the radio
and RAM3 ( CMP30 ) Remote
Station Microphone.
3. Press the PTT switch on the
radio. "Talk" will be shown on
the display.
Note: A warning beep will be
heard when the Radios PTT
and RAM3 ( CMP30 ) PTT are
pushed at the same time.
4. Speak slowly and clearly into
the microphone, hold the mi-
crophone about 1/2 inch away from your mouth.
5. When finished, release the PTT switch.
6. Press the

8.12.2 Calling

Press and holding the
GX2000/GX2150 or RAM3 ( CMP30 ) Remote Station Microphone will produce
a calling beep to the other station.
Page 40
soft key to enable the intercom
soft key may have to be pressed to see the
key to exit intercom mode and revert to radio mode.
soft key when in intercom mode on either the
GX2000/GX2150
( GX2000/GX2150's PTT switch is pressed )
GX2000/GX2150
( RAM3's PTT switch is pressed )
RAM3
RAM3
GX2000/GX2150