Scan Type; Scan Resume - Standard Horizon GX2150 Owner's Manual

11.3 SCAN TYPE

This selection is used to select the scan mode between "Memory Scan" and
"Priority Scan". The default setting is Priority Scan.
1. Press and hold down the
Menu" appears.
2. Rotate the CHANNEL knob to select "CH FUNCTION
SETUP".
3. Press the
with the CHANNEL knob.
4. Press the
5. Rotate the CHANNEL knob to select "PRIORITY
SCAN" or "MEMORY SCAN".
6. Press the
ting.
7. Press the
radio operation.

11.4 SCAN RESUME

This selection is used to select the time the GX2000/GX2150 waits after a
transmission ends before the radio start to scan channels again. The default
setting is 2 seconds.
1. Press and hold down the
Menu" appears.
2. Rotate the CHANNEL knob to select "CH FUNCTION
SETUP".
3. Press the
SUME" with the CHANNEL knob.
4. Press the
5. Rotate the CHANNEL knob to select the desired
resume time, default is 2 seconds. The resume time
can be set to "1SEC" through "5SEC", or "OFF". In the
"OFF" selection, the scanner will resume after the
other station stops transmitting (carrier drops).
6. Press the
ting.
7. Press the
radio operation.
GX2000/GX2150
soft key, then select "SCAN TYPE"
soft key.
soft key to store the selected set-
soft key several times to return to
soft key, then select "SCAN RE-
soft key.
soft key to store the selected set-
soft key several times to return to
key until "Setup
key until "Setup
Page 89