Position Reply; Auto Position Interval; Dsc Beep - Standard Horizon GX2150 Owner's Manual

14.6 POSITION REPLY

The GX2000/GX2150 can be set up to automatically (default setting) or manu-
ally send your position when requested by another vessel. This selection is
important if you are concerned about someone polling the position of your
vessel that you may not want to. In the manual mode you will see the MMSI or
persons name shown on the display allowing you to choose to send your posi-
tion to the requesting vessel.
Refer to section "9.8.1 Position Reply Setup" for setting.

12.7 AUTO POSITION INTERVAL

The GX2000/GX2150 has the capability to automatically track four stations
programmed into the Indvidual directory.
Selecting Auto DSC Polling time interval between position request transmis-
sions to be setup.
Refer to section "9.11 AUTO DSC POLLING" for setting.

14.8 DSC BEEP

This feature allows the alarm beeps to be turned on (default setting) or off
when a DSC call is received. The DSC calls that can be customized are: Indi-
vidual, Group, All Ships, Position Request, Position Report, Geographic Call
using the procedure below:
1. Press and hold down the
Menu" appears.
2. Rotate the CHANNEL knob to select "DSC SETUP"
menu.
3. Press the [ SELECT ] soft key, then select "DSC BEEP"
with the CHANNEL knob.
4. Press the [ SELECT ] soft key, then rotate the CHAN-
NEL knob to the desired DSC call type and press
the [ ENT ] soft key.
5. Rotate the CHANNEL knob to turn "On" or "Off" the
DSC beep and press the [ ENT ] soft key.
6. Press the [ QUIT ] soft key several times to return to
radio operation.
GX2000/GX2150
key until "Setup
Page 95