Parts Removal And Replacement; Covers; Mid Cover; Top Cover - Stairmaster FreeClimber Systems Owner's Manual

•
•
•

PARTS REMOVAL AND REPLACEMENT

COVERS

TO REDUCE THE RISK OF INJURY, DO NOT OPERATE THE MACHINE
WHILE THE COVERS ARE REMOVED.
WHILE ANYONE'S HANDS ARE INSIDE THE MACHINE.
There are three covers on the 4400 PT/CL and the 4200 PT: the top cover, the mid
cover and the bottom cover. The top and bottom covers are made of a right and
left section. Do not separate the right and left sections of either the top or
bottom covers to perform most maintenance
machine takes three steps: remove the mid cover; slide the top cover upward;
and remove the bottom cover (see Figure
The 4600 PT/CL has an additional shield over the
Access to the interior of the machine takes four steps: remove the mid cover;
remove the shield; separate the top covers and remove the bottom cover.

Mid Cover

1. Use the fastener removal tool to remove each of the four fastener
pins on the mid cover (see Figure
2. Stand on the pedals and keep them on the
3.
SI ide the mid cover down and away from the machine. Remove
the cover from the frame
the upper stops.
lop Cover
1.
4400 PIICl, 42ooPI:
4. Release the pins along the middle seam of the top cover. Use a
small phillips screwdriver or similar tool to push the fastener center pin
in at least halfway. Use your fingers to remove the fastener base from
the cover and then separate the top
Page 48
WARNING
DO NOT DEPRESS OR RAISE THE PEDALS
tasks. Access to the
27).
handles.
28).
floor.
tube. Carefully let both pedals return to
Remove the mid cover and the console.
covers.
interior of the