Step Chain - Stairmaster FreeClimber Systems Owner's Manual

•
•
•
PARTS REMOVAL AND REPLACEMENT
4. Check to ensure that the spring pulley turns freely and
excessively. Refer to the
the pulley.
5. To reinstall the spring, connect it to the end of the step chain using the
master Iink.
6. Route the spring under
pulley shaft (see Figure
7. Hook the end of the pedal arm return spring onto the spring hanger.
DO NOT TWIST THE SPRING DURING
EXCESSIVELY AND REDUCE THE LIFE OF THE SPRING
Reinstall the covers.
8.

STEP CHAIN

1. Remove the bottom
2. Remove the step chain
Support the pedal arm.
3.
Lift the step chain up and off the clutch sprocket and
spring hanger.
lower the pedal arm to the floor.
4. Remove the double-pitch master link (PN 21298SV) and bearing sleeve
assembly from the step chain connection point on the pedal arm.
5. Remove the master link from the spring-chain
6. Reverse the procedures to reinstall the step cha
chain before reinstalling the
Page 52
"Spring Pulley" section if
the spring pUlley that is fastened
10).
WARNING
INSTALLATION.
cover.
retainers.
Unhook the pedal arm return spring from the
connection.
in.
covers.
is not worn
you have to replace
to the spring
IT WILL WEAR
.
Lubricate the step