Download
Share
Print this page
Stairmaster SC5 StairClimber Assembly Manual
  1. Manuals
  2. Brands
  3. Stairmaster Manuals
  4. Fitness Equipment
  5. SC5 StairClimber
  6. Assembly manual

Stairmaster SC5 StairClimber Assembly Manual

Hide thumbs Also See for SC5 StairClimber:

Advertisement

Quick Links

Download this manual See also: Owner's Manual
6&  6WDLU&OLPEHU
Assembly Manual

Advertisement

loading

Related Manuals for Stairmaster SC5 StairClimber

Summary of Contents for Stairmaster SC5 StairClimber

  • Page 1 6&  6WDLU&OLPEHU Assembly Manual...

  • Page 2: Table Of Contents

    Table of Contents Model SC Specifications ................................2 ........

  • Page 3: Important Safety Instructions

    Contact your doctor before using the machine again. Examine this machine for loose parts or signs of wear. Pay special attention to the pedals. Contact Customer Service for repair information. Use only genuine StairMaster® replacement parts. Set up and operate your StairClimber on a hard, level surface.
  • Page 4 Hardware Ref # Description 5/16 " - 18 Hex Head Screw 1/4 " - 20 x 1/2" Button Head Screw 1/4 " - 20 x 1-1/4" Hex Head Screw 5/16 ” - 18 Nut 5/16” - Flat Washer 5/16 ” - Split Lock Washer 1/4”...

  • Page 5: Safety Warning Labels

    Safety Warning Labels Before using your product : Find and read all warning labels before using your product. Replace any warning label if damaged, illegible, or missing. If you need replacement labels, please call a StairMaster ® representative at 1-888-678-2476.

  • Page 6: Before You Start

    Before You Start ® Locate the area where you will assemble and use your StairMaster i l C . r e We recommend you install it on a hard, level surface. Allow an assembly area of at least 36” (0.91 m) on each side and behind the machine.

  • Page 7: Assembly

    Assembly Step 1: Removing Box Tools Box knife or Strap Cutters Claw hammer 1-1 Use the box knife to cut and remove the plastic banding straps from around the pallet and carton (see Figure 1) . Use extreme Caution when using shears or a razor knife.
  • Page 8 Assembly Step 3: Removing Console/Upper Mast Tools Box knife 3-1 Using the box knife, open the top of the box holding the Console/Upper mast weldment (see Figure 4). 3-2 Bend the box center flap inward. Remove Box 1 and place to the side. 3-3 Carefully lift the console/upper mast weldment out of the box and place to the side (see Figure 5).
  • Page 9 Assembly Step 4: Removing the Main SC 5 Body 4-1 Pull the lower body of the SC forward, and with the assistance of another person lift the machine o the shipping pallet and on to the floor (see Figure 6). Step 5: Removing Covers Tools Phillips screwdriver...
  • Page 10 Step 6: Routing Main Cables Top of Upper Mast- 6-1 Route the Main cable and the TV cable located at Console Plate the top of the lower mast through the bottom of the upper mast weldment and exit out the console plate (see Figure 12).
  • Page 11 Assembly Step 8: Attaching handrails Tools 5/32" or 4mm T-handle Hardware Ref 2: 1/4” - 20 x 1/2” Button Head Screw, Qty 2 Ref 3: 1/4”- 20 x 1-1/4” Hex Head Screw, Qty 4 Ref 7: 1/4”- Flat Washer, Qty 4 Figure 12 Ref 8: 1/4”- Lock Washer, Qty 4 NOTE: This Step requires 2 people to complete Steps...
  • Page 12 Assembly Step 9 : Replacing the Leg Levelers 9-1 Replace the 2 leg levelers previously removed in Step 8 (see Figure 16). 9-2 Return the SC 5 s t i sition. Step 10: Attaching the Console Tools Figure 16 Phillips screwdriver 10-1 Grasp the SC 5 console and connect the HRC cable from the upper mast weldment to the PC board cable (see Figure 17).
  • Page 13 Assembly Step 12: Final Check Failure to visually check and test assembly before use can cause damage to the equipment. It can also cause serious injury to users and bystanders. 12-1 Tighten all hardware. 12-2 Read all warnings on machine. Refer to the Owner’s Manual for: Operating Instructions Maintenance Instructions...

  • Page 14: Contacts

    4400 NE 77th Ave, Suite 300 Vancouver, Washington, 98662 Tel: 1-888-678-2476 Fax: 1-360-314-2865 Please supply the serial number of your machine and the date of purchase when you call StairMaster. Safety Warning Label information page. Serial Number Date of Purchase Assembly Manual...
  • Page 15 © 2011 Core Fitness, LLC, dba StairMaster. All rights reserved. StairMaster and the StairMaster logo are either registered tradema rks or trademarks of Core Fitness, LLC. All other trademarks are owned by their respective companies. StairMaster, 4400 NE 77th Ave. , Suite 300, Vancouver, WA 98662...

This manual is also suitable for:

Freeclimber