Battery Charge; Battery Disposal - Stairmaster FreeClimber Systems Owner's Manual

•
•
•
shafts with a dry cloth.
coat of mUlti-purpose grease before reassembling
8. Remove the pedals every three
leveling arm pin with a dry
arm pin from corrosion with a light coat of mUlti-purpose grease before
reassembl ing.
TO REDUCE THE POSSIBILITY OF
AREA IS FREE OF GREASE OR OIL. WIPE ANY EXCESS OIL OFF
THE MACHINE SURFACES.

Battery Charge

If you have a 4600/4400 CL, remove the bottom cover and check the battery
voltage level every three months.
1. Using your multimeter,
terminal of the battery and the black lead to the negative terminal.
2. If the voltage level is less than 6.1
the wall pack battery charger into the connector located near the
bottom of the left bottom cover. Charge the battery for approximately
24 - 48 hours and then recheck it. It is okay to use machine while the
battery charger is connected.

Battery Disposal

When ordering new batteries, you will need to properly dispose of (recycle) your
old lead-acid batteries. Most federal and state regulations requi re lead-acid
batteries be recycled.
Do not throwaway old batteries. Lead is a toxic heavy metal hazardous
to living organisms. Disposal instructions and a list of recycling centers are
tabulated in the Appen. d ix. If you have
Department at (800) 331-3578.
MAINTENANCE INSTRUCTIONS
Protect the shafts from corrosion with a thin
.
months. Clean the pedal shaft and
cloth. Protect the pedal shaft and leveling
WARNING
SLIPPING, BE SURE THE PEDAL
touch the red lead to the positive
VDC, charge the battery. Plug
questions, contact the Customer Service
Page 35