Alternator - Stairmaster FreeClimber Systems Owner's Manual

•
PARTS REMOVAL AND REPLACEMENT
5. Tilt the machine forward and use an extended socket to remove the
two handrail adapter screws from the front leg of the
6. Tilt the machine back into place and pull each handrail out sideways.
Be aware that the handrail extrusion connects the left handrail to the
right handrail, and may fallout when one side is removed .
7.
Reverse the removal procedures to reinstall the handrail.

ALTERNATOR

1. Remove the bottom
attached to the alternator (see Final Assembly Diagram). Remove the
wires from the alternator.
2. Loosen and remove the alternator adjusting bolt on the slotted
Remove the Poly-V belt. Inspect the belt for wear and replace the belt if
it is cracked, cut, or is otherwise
Loosen and remove the nyloc nut from the alternator post. Remove the
3.
alternator from the frame.
4. Reverse the removal procedures to install the new
verify the wiring against the Final Assembly
5. Pivot the alternator up or down as necessary to allow
(0.6 cm) of belt deflection with finger tip pressure at the center of the
vertical portion of either side of the belt (see Figure
Page 60
cover. Mark (by color) the location of each wire
damaged.
Diagram.
machine.
brace.
alternator. Be sure to
1/4"
30).