Power Switch - Xerox 6110MFP/XN Service Documentation

System Overview

Power Switch

The Switch is located at rear-side of printer and must be marked to indicate on and off.
Sensor
Paper empty (Cassette)
CRUMS
The Phaser 6110 MFP engine will be equipped with electronics that can read and write data into NVRAMs otherwise
known as CRUMs that reside within 1) C, M, Y, K Toner cartridges and 2) Imaging kit (Developer, OPC, ITB). The CRUM
has a company ID, and Xerox electronics logo.
The toner CRUM also identifies the type of toner cartridge (Standard or High Capacity). The CRUMs contain fixed data
such as the low warning point, specified life point, and hard stop point (on toner, not on IBT unit) and also store the cur-
rent life count (pages count, pixels count, images count) and % of usage (gas gauge) data.
LOW / OUT Behavior for consumables
The consumable low and out behavior on Phaser 6110 MFP engine is specified by SEC.
FP Device for life end
message detection
Toner CRUM
Imaging Kit CRUM
Fuser No
T2 Roller No
Pick-up No
3-28
Law(90%) Life(100%)
Yes Yes
Yes Yes
Yes Yes
Yes Yes
No No
Hard stop Reset to 0
Yes(115%) No
No No
No Yes
No Yes
No No